|
Why can't wheeled excavators walk normally? Look hereCheck that the tire transformation is outstanding and the transmission Shaft-driven bicycle is normal; Disassemble the pilot oil pipeline for operating the excavator in high and low gears, switch to high and low gears, and investigate the strong and powerful oil output of the oil pipeline, which can clean up the problems of the shift valve and hydraulic oil circuit; Turn off the engine and the walking equipment is in a stop and brake condition. Open the transmission case investigation cover and check the gear shift fork. You can feel the middle part of the fork cracking by hand and it is detached from the sliding sleeve. It is preliminarily determined that the fork cracking is the problem. 1. Reason for the problem Based on the fracture condition of the fork, the cause of the problem is analyzed as follows: during the internal process, the machine had not completely stopped before switching between high and low gears. The transmission box of a second-hand excavator does not have a synchronizer installed. During the trek of a mesh machine, the internal transmission gear runs at high speed. If the gear is shifted at this moment, the sliding gear sleeve of the shifting fork cannot fully mesh with the gear, and the reaction force caused by collision directly causes damage to the shifting fork. It is decided to replace the fork for this purpose. 2. Disassemble the transmission box The disassembly process is divided into several steps: first, loosen the hydraulic oil tank cover and exhaust the hydraulic system, disconnect the hydraulic pipeline connected to the transmission box, and close the oil leakage point; Secondly, remove the front and rear transmission shafts, remove the hand brake hydraulic cylinder and front axle drive hydraulic cylinder oil pipes; Once again, place the adjustable lifting device at the lower part of the transmission box for disassembly and assembly, adjust the lifting device to support the box, remove the three fixing bolts of the transmission box, and remove the transmission box from the frame. Due to the large mass of the transmission box, it is necessary to acknowledge that the elevator fully accommodates and supports the box before disassembling the fixing bolts. The differentiation steps of the transmission box: Firstly, open the transmission box cover, and sequentially remove the cylinder head lock nut, piston, O-ring, centering plate, tightening spring, spring seat, pin, retaining ring, shaft, fork, and control lever. Secondly, replace damaged control levers, forks, and aging O-rings. Finally, inspect the wear condition of the internal transmission shaft and gears of the transmission box, and acknowledge whether the condition of each component is outstanding. 3. Assembly and testing machine Assemble the disassembled parts one by one. Assembly is the Reverse Course of disassembly. After assembly, connect the recovered transmission box device to the frame and connect the corresponding hydraulic pipelines. Finally, tighten the hydraulic oil tank cap and start the engine, lift the bulldozer, and test the machine in high, low, and reverse gears separately. The problem was not found. |